Configure Maximum EAP Clients

About this task

Use this procedure to configure the maximum EAP clients allowed on the port at one time.

Procedure

  1. Enter GigabitEthernet Interface Configuration mode:

    enable

    configure terminal

    interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

    Note

    Note

    If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

  2. Configure the maximum EAP clients:
    eapol multihost eap-mac-max <0-32>
    Note

    Note

    eap-mac-max is also used to provide EAP and NEAP separation functionality. By default the EAP clients are enabled per port and eap-mac-max limit is 2. If eap-mac-max is set to 0 then EAP client authentication is disabled.

Example

Configure the maximum EAP clients allowed on the port at one time.

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#interface gigabitEthernet 1/1
Switch:1(config)#eapol multihost eap-mac-max 10

Variable Definitions

The following table defines parameters for the eapol multihost eap-mac-max command.

Variable

Value

<0–32>

Specifies the maximum EAP clients allowed on the port at one time. The default is 2.